Accessories for ergonomics
PISTOL GRIP
To convert straight screwdrivers into pistol screwdrivers.
AUXILIARY GRIP
When using straight screwdrivers at torques higher than 4 Nm, it is good practice to use the auxiliary grip, which reduces the reaction by distributing it over two hands rather than one.
CONNECTION CABLE WITH 90° RIGHT ANGLE CONNECTOR
Useful when converting the screwdriver from straight to pistol and the power cable drops from above.
MULTIPLE CONNECTOR FOR I/O
To be connected to the 25-pole I / O ports of Fiam TPU units. It allows to make the I/O signals available on 3 connectors and therefore the connection with 3 devices in parallel. Equipped with connection cable between unit and multiple connector and relative power supply, it has 8 status LEDs for Outputs and 8 test buttons for Input signals.
SPS — SOCKET AND PROGRAM SELECTOR
Poka yoke device for selection of fastening program by picking up of sockets/bits to be used for different applications. It can work together with Fiam unit TPU-C3. It allows the selection of up to 8 sockets or bits (with diameter up to 80 mm) and checks correspondence between socket and pre-set tightening program as indicated from linked controller. Selection LEDs and socket pick-up acoustic signal (buzz): each socket spot is indeed connected to a particular program in the controller so that, when the worker picks one socket the controller is automatically set in accordance. In particular using TCS3 controller the operator can carry out a correct tightening sequence by picking-up the socket indicated from lightened LED in the SPS.
